The Mopar Powered RETRO SERIES harness is designed with 40+ years experience in the do-it-yourself wiring business. It is very similar in design to what Ron started with in 1974 but with a few twists and turns to bring it up to today’s capabilities! It is a 12 circuit model that is nearly completely pre-wired. A ‘drop in’ harness for that cost conscious enthusiast who does not intend to upgrade any components other than the running gear and steering column. Uses Hi-Temp cross-link wire, and has a serial number for fast troubleshooting help.
The RETRO SERIES is ready for stock Mopar Alternators; up to 140 amp, or more, One Wire alternators, and other aftermarket units. It will wire your turn signals, headlights, tail lights, brake lights, gauges / senders, engine (starter, alternator, distributor), ignition switch, headlight switch, Hi/Lo Dimmer Switch, 3rd Brake Light & License Plate Light. It can be used for a dash mounted or steering column mounted Key, Hi/Lo and turn signal Switch.
• Barely need the instructions
• Not a ‘watered down’ universal harness like competitors offer
• Wire lengths predetermined
• Wires clearly printed showing the function of each wire
• Terminals & connectors installed on most of the wires
• Ready to connect to the electrical devices
• Limited to basic needs
Note: Block with relays and flashers is a separate unit to be mounted next to or near the fuse blocks. Combined unit in photo is for display purposes only. Product may vary from photo.