Miscellaneous Lighting-Ron Francis Wiring

This really cool 'behind the dash' trouble light is always there when you need it. Usually mounted above the gauges to provide light in hard to see locations. This 3 foot long light has a super white light that does the job. Note the ability to actually read the paper with no other illumination.

$57.95

BA-15

Back-Up Light Wires

Wires used to hook up back up lights.

$19.95

DL-39

Dome Lt 3 7/8 Diameter

This attractive light measures 3-7/8" in diameter and has a clean flush mount. Polished Aluminum w/quality lens.

$68.95

EL-39

No Load L.E.D Flasher

Plugs directly into original flasher location on fuse box, electronic. Here we have a more economical turn signal flasher for use with LED lights in the front or rear of your car or truck without aggravation. This unit can flash your LED's or combination of incandescent bulbs. Should not be used with vehicles operating more than normal lamps like trailers or extra incandescent bulbs.

$59.95

TS-15

Under Hood & Trunk Light Switch

One kit - with one light

This slick ball switch is attached to your trunk or hood lid to turn the light on when opened. Includes a relay if you have something of higher amperage you’d like to turn on also. Only the small ball switch is mounted on the lid and can easily be concealed. This kit includes ONE light.

Part # TS-15 is one wiring kit that contains ONE light.

Part # TS-16 is one wiring kit that contains TWO lights.

Part # TS-30 is a Two-Pack of TS-15s, which would be two wiring kits, each with one light.

$39.95

TS-16

Under Hood & Trunk DUAL Light Kit

One kit with TWO lights

This slick ball switch is attached to your trunk or hood lid to turn the lights on when opened. Includes a relay if you have something of higher amperage you’d like to turn on also. Only the small ball switch is mounted on the lid and can easily be concealed. This kit includes TWO lights for even better visibility where you need it!

Part # TS-15 is one wiring kit that contains ONE light.

Part # TS-16 is one wiring kit that contains TWO lights.

Part # TS-30 is a Two-Pack of TS-15s, which would be two wiring kits, each with one light.

$50.95

TS-30

Under Hood & Trunk Light Kit - TWO-PACK

Two kits, each with one light. One for the hood and one for the trunk!

This slick ball switch is attached to your trunk or hood lid to turn the light on when opened. Includes a relay if you have something of higher amperage you’d like to turn on also. Only the small ball switch is mounted on the lid and can easily be concealed.

Part # TS-15 is one wiring kit that contains ONE light.

Part # TS-16 is one wiring kit that contains TWO lights.

Part # TS-30 is a Two-Pack of TS-15s, which would be two wiring kits, each with one light.

$61.95

LC-16

License Plate Lightt & Bracket Assembly

$49.95

TM-20

ADJUSTABLE DELAYED-OFF TIMING MODULE

Put a delay on your interior light!
Excellent kit for wiring a delay on your interior light or any other device. Adjustable for 1 to 120 seconds. Capable of handling up to 40 amps.

$138.95

AL-13

Auxiliary Lighting Feed Wires

Color-coded, Printed Feed Wires

$20.95

DL-24

Driving Light Relay

Boost the lamp output to your driving lights using this relay. Battery voltage is delivered more directly and increases light output. Comes with printed wiring, relay and fuse.

$42.95

PT-10

Single Light Socket Repair

For repairing single contact sockets.

$4.50

PT-18

Double Light Socket Repair

Use PT-18 for repairing double contact sockets. May be used to convert single socket to double. Requires special bulbs like our 1005, 1005A, 1087 or 1004 with straight across pins.

$4.50

LC-8

Lamp Contact

For socket repair. 8 Pieces. Product may vary from photo, slightly.

These are the contacts that are crimped to wire ends after they are inserted into the lamp sockets. They make contact to the base of the bulbs. For either double or single filament bulbs.

$10.95

LC-99

Lamp Contacts

For socket repair. 50 Pieces. Product may vary from photo, slightly.

These are the contacts that are crimped to wire ends after they are inserted into the lamp sockets. They make contact to the base of the bulbs. For either double or single filament bulbs.

$20.95

Page 1 | 2