In The News
Qty in Basket : 0
Call Us Toll Free at
LATEST & GREATEST! - NEW PRODUCTS
FACTORY FIVE WIRING HARNESS
REFERENCES FOR ORDERING KITS
COOLING FAN CONTROL WIRING
GROUNDING & CHARGING ACCESSORIES
POLISHED ALUMINUM KNOBS & BEZELS
FORD REPLACEMENT & PERFORMANCE HARNESSES
RACE & PERFORMANCE
THE DETAIL ZONE - FUEL INJECTION WIRING
TECH TIPS & ENCYCLOPEDIA
6 VOLT PRODUCTS
Can we make a harness for you?
Terminals, Housings & Connectors
Housings & Connectors
Click on the column heading to sort the results
PP-3 Potluck Piigtail - Triple Contact
TK-6 6 Gang Weatherpak Connector Kit
Available in 1, 2, 3, 4, 5 & 6 Gang configurations. These connectors provide a weather resistant seal. Come in complete kits with a couple extra terminals. Compatible with 14 to 20 gauge wire.
QCK-8 Eight Quick Connector
Each part number has everything necessary for one joint. Bodies lock together. All housings below are supplied with correct brass contacts that fit properly. Wires must be inserted in terminal before insertion into plastic body. These connectors work best with 18-14 gauge wire. Note: QCK-8 does not feature a lock but connector requires much effort to disconnect once installed.
PP-4 Potluck Piigtail - Four Contact
Ford Early AIT/ACT Connector Pigtail
Pigtail for Early Ford ACT/AIT Sensor.
FOXBODY/FORD CLUTCH SWITCH PIGTAIL
Pigtail fits Ford/Foxbody clutch interrupt switch.
PP-6 Potluck Piigtail - Six Contact
PP-8 Potluck Piigtail - Eight Contact
Ford T5 Backup Light Sw. Connector w/ Pigtail
Factory correct molded connector with 9 inch wire leads. Connects to most any Ford T-5 manual trans and others.
Ford VAM Pigtail with 36 leads
Vane Air Meter connector with 36 inch leads.
Ford Round TPS Connector Pigtail
Factory correct connector with wire leads. Connects to Ford TPS Sensor from early 80's until early 90's.
AOD Neutral Safety-B/U Light Connector Pigtail
Factory correct molded connector with 16 inch wire leads. Connects to most any Ford AOD automatic trans.
PASS THRU, 22 WAY WEATHERPACK
The PT-22 is a 22-pin bulkhead connector for passing wires through a panel, bulkhead or firewall. This connector provides a weather resistant seal and comes in a complete kit with bolt fasteners, locks, seals and a few extra terminals for your convenience. The PT-22 accepts between 10 and 18 gauge wire.