In The News
Qty in Basket : 0
Call Us Toll Free at
LATEST & GREATEST! - NEW PRODUCTS
FACTORY FIVE WIRING HARNESS
REFERENCES FOR ORDERING KITS
COOLING FAN CONTROL WIRING
GROUNDING & CHARGING ACCESSORIES
POLISHED ALUMINUM KNOBS & BEZELS
FORD REPLACEMENT & PERFORMANCE HARNESSES
RACE & PERFORMANCE
THE DETAIL ZONE - FUEL INJECTION WIRING
TECH TIPS & ENCYCLOPEDIA
6 VOLT PRODUCTS
Can we make a harness for you?
Odds 'N' Ends
Click on the column heading to sort the results
WR-73 Power Plug Receptacle
Use to recharge your cell phone and other electronic devices. This is not for a cigarette lighter. Uses 1-1/8" mounting hold. Bracket also included.
VR-88 Voltage Regulator (only)
For those with Externally Regulated alternators, regardless of make.
RON FRANCIS WIRING KEYCHAIN (NO KEYS)
LS-11 Lo Voltage Sensor
The popularity of the one wire alternator is certainly well known. Manufacturers are doing all they can to supply the high amperage needs to todays average street rodder. The "ONE WIRE" circuits has eliminated the wiring normally used to control other vehicle functions like the "idiot" light on the dash. The "warning" light is far more visible and attracts your attention much faster then a gauge where the reading / needle may be slowly dropping.
Warning lights provide a quick indication that something has reached the danger point and your electrical system is near the point where a fuel injection engine is about to misfire, a cooling fan will begin to overheat and fail or any electronic circuits is about to shut down. [ Most electronic circuits need about 10 volts to operate.
This product is a voltage sensor that is used with any alternator to light an indicator (idiot) light when the vehicle voltage drops below 11 volts. They can be used in conjunction with a voltmeter, ammeter or by themselves.
This is a simple hookup of a key 12 volt source, a ground and a lamp. You can use an LED, small indicator like those sold by RFW or an existing factory idiot light like those use in most original factory classics.
HR-57 ADAPTER-HR-56 TO DS-05 DIMMER SWITCH
If you are using our Toggle Dimmer Switch with OUR kit, this adapter allows you to 'adapt' the pre-installed plug to the ring-type terminal connections on the back of the toggle without having to splice.
HP-37 Express Panel Drop Down
FUSE PANEL "DROP DOWN" When you need better access to your fuse panel, use this slick DROP DOWN bracket. Just install and wire the car. When finished you can "unhook" and drop the panel down for better access. Fits Express Panels & Bare Bonz II Panels Only.
HP-36 Bonz Panel Drop Down
FUSE PANEL "DROP DOWN" When you need better access to your fuse panel, use this slick DROP DOWN bracket. Just install and wire the car. When finished you can "unhook" and drop the panel down for better access. Fits original Bare Bonz (Black or Silver) Panels Only. (Photo shown is of Express version. Bonz version same, only smaller)
Friction Tape/Harness Wrap Tape
Non-Adhesive Friction Tape that sticks to itself (just like the OEMs use). Does not the sticky residue and other issues associated with electrical tape. 36 yards.
CT-25 Insul. Crimp Tool
This tool crimps insulated and non-insulated terminals as well as having a cutter and stripper feature.